ST Battery Interval Change

There are many factors that may interfere with an over the air command sent to your tracking device, and we are therefore unable to offer any guarantee regarding this process.  We record each command sent to the unit, and sending any over the air command to a SageTracker Battery device other than those listed below is a violation of your service agreement and may result in the deactivation of the device and termination of your service agreement.

Please note that this procedure is for SageTracker Battery units shipped after March 31, 2007 only.  If you purchased your device prior to March 31, 2007, please contact us to change your reporting interval.

Change the Reporting Interval

Below is the list of commands that can be used to program the device to report at various intervals.

Step 1: Log on to the SageTracker web based tracking account.

Step 2: Click the “Launch Messaging Window”.  If you have more than tracking device in your account, be sure to select the proper vehicle to send the command to in the pull down menu in the center of the window.

Step 3: When the messaging opens, cut and paste the appropriate command string from the tables below into the small rectangular window at the bottom of the screen:

Step 4: After you have pasted the command into the messaging window, press “Send” to send the command message.  The text in the very bottom left hand corner of the messaging window browser should change from “Ready” to “Sending” and then to “Sent”. At this point you can close the messaging window.

Step 5: Go to the home page of your tracking website and select “Today’s Track” and the click “Show Me”.  The outgoing message string should be shown under the column labeled “Messages”.  The outgoing message will not be received by the device unit until its next reporting cycle, which will occur at the next time the device detects motion (if the unit is already in motion, a new reporting cycle will occur at the device’s programmed Report Interval).